Tag: EzCap

Viewing Report 3rd March 2020 – Travel Scope

Viewing time period – 19:37 – 22:35

Back out again tonight for a short period to look at guiding again. So with everything setup and a longer USB 2 cable in use I am now sitting in the warm Orangery. I will try again with the PHD2 software to guide and EzCap to acquire images from the QHY168C. I have set the Gain to 7 and Offset to 30 as previously used on my other QHY168C when used in Tenerife.

I polar aligned using PoleMaster. Then set about syncing the scope with Betelgeuse. It was only off slightly. The sync worked fine tonight. I then slewed to M35 and started the PHD2 guider software, selected a guide star and calibrated the guider. This worked well first time proving my new step size of 4 using a small ms time for the pulse worked.

Then I started guiding and very quickly realised the same problem as yesterday with DEC drift upwards. No amount of fiddling with the setting such as Hysteresis or Aggressiveness changes the constant upwards drift. I then remembered that I could calibrate the settings as the other night under Guider Assistant. I ran this made the changes but still the upward drift.

I then remembered that on the Paramount MEII in the dome I had to drift align with PHD2 to get it properly polar aligned and that PoleMaster was only good enough for short exposures or rough guiding. So I set about drift aligning.

PHD2 Drift Alignment

The first thing to note is that the polar alignment was out by a fair bit to get the accuracy I require in both azimuth and altitude. I have now adjusted both and the graph seems a lot smoother.

So in all it took me around 1 hour to drift align and just as I was about to test the clouds rolled in!

Clouds start to roll in

Viewing Report 1st March 2020 – Travel Scope

Viewing time period – 17:35 – 23:00

First time out for a very long time with the travel setup. I need to get the guiding working before the Tenerife holiday in July. I have left Bob to play with the IMT3 whilst I work through the bugs.

The challenge is at first remembering how to set everything up. I found after some effort I was actually missing a cable, it was in the black wheelie case in the garage with the laptop tent and scope daytime cover, but more about that later.

So So after finding a place on the patio where I could feed the USB cable through the Orangery window, I put the Berlebach tripod down and placed the MyT mount on top. I tightened the screws and then placed the Sky-Watcher Esprit 120 ED on top of the Versa Plate. Once in position I balanced the scope then connected the various cables, now all through the mount due to my good friend Bob making up some power connectors for me.

So I tried to guide through PHD2. There was a large wind blowing. On trying to calibrate the scope would not move. After what seemed like an hour I remembered that cable, this was again the ST4 guider cable that is needed on the Mac if you are guiding with PHD2 as there is no ASCOM. So I connected the ST4 cable and it worked.

What I could not achieve tonight was to get the guide graph behaving, it was a mess. The wind was at fault but still there were other issues, not least the slider to control the contrast of the screen was causing anything above 0.5s to become white.

Guiding a mess with PHD2

After many hours I gave up and brought the rig in. I had been using TheSkyX to slew there scope, PHD2 to guide and EzCap to connect to the QHY168C camera and take images. I will try again tomorrow night.

EzCap image of Betelgeuse