February 2022 – IMT3b Observatory

Exoplanet HAT-P-66b (25/2/2022) – IMT3 + Visual with 22″ Dob!

21:24 – 03:00

So for the first time in a while the observatory is back up and running and it’s Friday and it’s clear! So Bob came over and we set about imaging an exoplanet and getting the 22″ Obsession dob out of the warmroom where it had been sitting since November, and moving it down to the observing plateau by the IMT3b observatory.

A few nights back, during the week I had managed to get the 12″ in the dome balanced with my original 2004, 5″ Skywatcher 130 reflector as a guide scope and the Skywatcher Esprit 120 ED on the other side. The 5″ now guides, however the QHY camera on the 120 is not currently connecting so I need to investigate. Also the MEII hand controller is sending erroneous signals to the mount so I needed to disconnect as it kept saying ‘joysticking’ and moving the mount. Unfortunately the 5″ was pointing at the dowel so I used off-axis guiding instead.

I selected an exoplanet on the Exoclock website, and set about imaging. Unfortunately due to my profile on exoclock being set to UTC +1 and me not noticing I started 45 mins into the transit! I will now use this as a test run and process the data and submit.

So first up was moving the 22″ down to the plateau so it could cool down. I had planned on taking it back up to the Warmroom, however it is so heavy I have decided to keep it in the workshop. I will make sure I connect the electric up for the workshop this weekend thus allowing for the new dehumidifier to be switched on and operational.

Whilst the 22″ cooled down, we went back indoors and setup the 12″ in the observatory to image the transit. The focus point was 25,000 and I made sure I selected the Red filter. I slewed and aligned on the exoplanets host star and then settled on a 5min exposure due to the low brightness. I started imaging at 9:24pm, the transit start was 8:45pm 🙁

Whilst imaging continued we went outside and set about setting up the 22″. Things I learnt from this first public outing were;

Remember to put the shroud on
Remember to pub the secondary shield on
Remember to collimate the secondary first
Remember to fit the Telrad dew heater
Remember to find a 40mm eyepiece
Remember to download and print the Parracor chart
Remember to set the Parracor to the correct setting
Remember to buy a 12v battery powered hair dryer
Remember to buy a secondary dew heater

We collimated the scope and then went on to look at M42 which with the 24mm Panoptic looked great. We then slewed to M45 the Pleiades but of course the open cluster is too wide for the for I was using. Then we tried find M81 and M82 but I found this difficult due to the lack of bright stars in the area. So instead we went to the Trio in Leo.

M65 and M66 looked fairly bright and you could make out the dark dust lane in M65. NGC 3628 was visible with direct vision, however with adverted vision it was much easier. It appeared very long and thin.

We had to use s hairdryer on the secondary a lot. The Telrad also dewed up as did the eyepiece. The primary mirror was fine, although with direct headtorch light looked like it was dewed, but upon inspection this was not the case.

At midnight it was time to pack up before I had to do a meridian flip. Bob helped my dismantle the 22″ dob and then place inside the workshop. I could not move it into the room without dismantling which was a shame. It is far too tall.

Once done, Bob headed off home for a well deserved rest and to warm up due to it being 0℃. I headed indoors and performed the meridian flip at 0:23am.

I then left the observatory running until 2:30am whilst I wrote this blog, had a glass of wine and ate an easter egg 🙂 I also went back out to the workshop to tidy up the telescope eyepieces etc that I had not put away.

At 3pm I went on to take luminance for M85 that I needed to complement the RGB data I had processed. I let this running and went to bed.

I took flats and dark flats in the morning, although I had to increase the exposure to get the required level for the flats. This is strange as they should be the same. I am now concerned the camera my be playing up and causing an issue. I will investigate.

Viewing Report – Kielder Water (18-20/02/2022)

So with short notice a couple of my friends booked a cottage just outside the Kielder Water park boundary in Northumberland. This was booked for same weekend that Storm Eunice and Storm Dudley hammered the UK, the drive from the South of England to the North was very gusty and interesting at times.

Suffice to say that during my short stay in a farm cottage I saw more of Pubs such as the local warm, very friendly and welcoming Star Inn and comfortable cottage fireplaces than I did clear nights.

On the first evening it was broken fast moving cloud so we settled on taking in the various views of the 17 day old moon (94.2%). Although it was very bright being just after full moon, we scoured the edge of the disc looking at the shadowed craters. The first evening’s session was cut short by the cloud and rain, which seemed to set the mood for the week.

On the next few cloudy nights, I spent the time upgrading to ASCOM 6.6, the latest NINA beta and SGPro 64bit. Of course this required me to make sure I had the latest 64bit drivers installed. Once done, I began testing the various bits of hardware within the applications.

Very welcoming when it is wet, windy and foul outside

However on my final evening whilst nestling a Talisker Single Malt in front of the fire. I just happened to peer outside and it was clear, breezy and cold but clear. So since the weather report said it would cloud up I grabbed the Baby Dob (SkyWatcher Heritage 150) and headed outside for a quick sky tour.

With Laurence and Laura we finally saw why astronomers come to the Northumberland National Park. The Milky Way was so obvious stretching from Orion in the South, through Perseus and Cassiopeia and the sheer number of stars was breath taking.

We started looking in Orion, the Orion Nebula (M42) which the 150P does not do it justice and really a 200P and decent eyepiece would be needed to show the wispy cloud structures. We looked at the stars Betelgeuse and Sirius (Canis Major) just to show the colours of these giants before moving along to view the Pleiades (M45) and the star clusters in the constellation of Auriga.

The Double Cluster (NGC 889/NGC 884) in Perseus in the 25mm wide field eye-piece was beautiful. From the Perseus/Cassiopeia border we moved through the milky way and across to Canes Venatici hunting down The Whirlpool Galaxy (M51) which we saw as two misty patches, one smaller fainter patch and a larger patch with a faint core.

Moving southwards we hunted for the globular cluster M3 which was low on the horizon and effectively in the trees but we managed to locate it. Again it was a misty patch and looked like a comet. Switching to the 10mm eye-piece I tried to resolve the patch as stars but I was unable to, maybe due to it’s low altitude but Laura was able to do so with averted vision.

Of course I also forgot that objects I can see from The South Of England are higher up in the sky compared to The North Of England by almost 4 degrees altitude.

Not long after we headed in doors to warm up, the clouds rolled in, the wind picked and the snow started falling as a precursor to the incoming Storm Franklin. Such is life but at least I got a few hours under dark skies even if it was visual and not deep sky imaging.

Viewing Report 5th January 2022

17:00 – 02:15

went out and put ZWO ASI120MC on the back of the ST80 guide scope. Refitted the Lodestar to the off axis guider. I then setup the FoV indicator on TSX and also got the guider to focus.

Took a bunch of M78 frames LRGB to start with. Then tried a 600s Ha but that showed very little.

Then joined by Bob joined and he reminded me to image JWST.

Then around 12:30am I started imaging M78 again on the other side of the meridian. I must sort out imaging with a frame so that it is easier to get the object inside the FoV and lined up as it took me quite some time this evening. Plate solving was also not working again within SGP so I need to look at that on the next night out.